DemoPad.com

Longtime iRule user looking for a replacement. I am impressed so far by Demopad but have run into a snag that I can't solve. I have set up several ip devices that are working fine but my openHAB device will not communicate (openhabian on RaspberryPi). This has always worked fine in iRule.
Using Hercules I have picked up what is being sent out.

From Demopad: From iRule: I have tried pasting the iRule command that was received by Hercules into Demopad but that did not work. I read in this forum about how to convert a command to "GET" but that did not wok either.

I am grateful for any help, Thanks

OK, after hours of testing and sifting through this forum, I finally found the answer. I post here to save others the time.
You must use HTTP/1.0\x0D\x0A after the command. Not HTTP/1.1 The suffix \x0D\x0A must be part of the command even though it is set in the device. So in my case the command would be;

Note that Hercules represents hexadecimal characters in {0D} format for example, you would need to swap to \x0D format within DemoPad. I suspect the HTTP/1.1 approach would have worked if these changes were made to the iRule command, but if HTTP/1.0 works anyway then it requires less parameters.

OK, yes, I see that now. Thanks for your comment.