Cannot get feedback to work

[DemoIan]

I am struggling to get feedback to work on a centro 8, I have setup a CYP CR-KP2 keypad as a device, it uses Telnet to communicate, I can send commands to the keypad and if I use app feedback then I get an automated response but not the response I programmed in the keypad.

http://www.cypeurope.com/store/store/ap ... rol-System

I have tried using the web interface, telnet, command in demopad and physically pressing the buttons but is seems the Centro doesn't see any feedback.

It should be a simple setup, the keypad sends a telnet command e.g.

KP1-K1-BLUESOUND\x0D\x0A

the Centro receives it and sets a flag

Does anyone have experience of these keypads, is telnet the best way to communicate? Any help would be gratefully received

[DemoIan]

Keypad Settings

[DemoIan]

I cannot connect to the Centro using Telnet, is this normal behaviour?

[DemoPad]

Yes this is expected, the Centro does not act as a telnet server, it typically acts as a client to control other devices

[DemoIan]

Looking at the manual that came with the unit, it differs from the on line manual all the telnet commands need to be suffixed with \0xd, i have tried this but still no luck, might try another port number.

[DemoIan]

Fixed!....... painful, Telnet commands have to be suffixed with \x0d but the feedback needs \x0d\x0a

Used Hercules to see what came back, the manual contradicted the online manual.